How To Use
PELA 650, Pro 14, PELA 6000 and PELA 2000

	1) Pre-run engine for about 5 minutes to warm the oil and to allow the sludge to mix and suspend in the oil. Remove the dipstick.
	2) Select and insert the appropriate diameter extraction tube into the dipstick pipe until it touches the bottom of the oil pan. Connect the main tube to the top of the unit and to the extraction tube.
	3) Pump the handle 4 to 15 times in a row to start the vacuum. The unit will extract the oil automatically. Continuous pumping is not required.
	4) After all the oil has been extracted, press the release valve located at the top of the unit for 5 seconds. Remove the main tube. When pouring the oil into a container, hold the pump as in the photo and pour gently. Bring the used oil to a recycling depot.
How To Use PELA 6000 & PELA 2000 Oil Extractors
	1) Pre-run engine for about 5 minutes to warm the oil and to allow the sludge to mix and suspend in the oil. Remove the dipstick. Insert the extractor tube into the dipstick pipe until it reaches the bottom of the oil pan. Firmly place the tube cap onto the container.
	2) Attach the pump to the top of the container.
	3) Pump 10 to 20 times in a row to create the vacuum (5 to 10 times for PELA 2000) . Always use 2 hands. The unit will automatically extract the old oil. Continuous pumping is not required.
	4) To stop extraction at any time, pull the tube out of the fluid.
	5) After all the oil has been extracted, remove the tube cap from the container with a twisting motion. Remove the pump. Empty gently into a container. Bring the used oil to a recycling depot.
Note: Not for use on gasoline or other flammables. Back to Pela Information
Home More Boat Gadgets Design A Boat Name Order (888) 774-7372